ElectroSport Industries

 

Technical Resources Library
 

 

 

 

Common Technical Issues: SUZUKI GSX-R600W

BRAND: SUZUKI
MODEL: GSX-R600W
YEARS: 92-93
CATEGORY: MOTORCYCLE

TECHNICAL ISSUE DETAILS
This Suzuki uses a car-type alternator that is mounted behind the cylinder block. Inside this alternator there is a field rotor with copper slip rings on which carbon brushes run. Around the rotor you will find the stator and in the front of the housing are the built in rectifier bridge and the electronic voltage regulator. Common faults: FAULT 1: OVERCHARGING THE BATTERY. This is usually caused by (1) a bad internal voltage regulator or (2) a bad electrical connection somewhere on the bike in the lead that provides battery voltage feedback to the internal voltage regulator (the voltage sensing wire) The replacement voltage regulator is our part# ESR025. This unit replaces the OEM unit even though it looks different. To find the bad connection to the voltage sensing wire you need to look at the leads coming from the alternator. There is one large diameter lead, usually RED, that is the output from the alternator to the battery. The thinner lead is the sensing wire for the regulator. Use a multimeter to measure the voltage on this lead to ground. It should be close to the battery voltage with the bike running (around 14Vdc). If you see a substantial difference (say: battery voltage 17Vdc, sensing lead 14Vdc)you should look for a bad connection somewhere between the battery and this sensing lead. Inspect all connections, the ignition switch, use spray contact cleaner on everything. Spend some time and you will probably find a bad connection somewhere. Fixing this connection should fix your overcharging issue. FAULT 2: NO OR LOW BATTERY CHARGING. This can be caused by a bad internal voltage regulator inside the alternator, or by a bad rectifier module. A bad voltage regulator sometimes is caused by a shorted out field rotor that is drawing too much current from the voltage regulator. Inspect the rotor resistance between the slip rings which should be 3.3-4.0 Ohms. Another cause could be bad connections between the alternator output and the battery terminals. Check all connections and see if this fixes the issue.

PRODUCTS AVAILABLE FOR THIS VEHICLE
See products available for the SUZUKI GSX-R600W, 92-93 MOTORCYCLE.



« Technical Resources Library :: Known Issues for Specific Vehicles

 

 

 

© 2010 - 2023 - www.Electronicamotos.com.ar - Buenos Aires - Argentina